Pnp/ Pci Configurations Page - PCchips M921 Series User Manual

Mainboard User's Manual
PnP / PCI Configurations Page
This page sets some of the parameters for devices installed on the
PCI bus and devices that use the system plug and play capability.
CMOS Setup Utility – Copyright (C) 1984 – 2001 Award Software
PNP OS Installed
Reset Configuration Data
Resources Controlled by
x IRQ Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
    : Move
Enter : Select
F1:General Help F59:Previous Values
PNP OS Setting this option to Yes allows the PnP OS
Installed (instead of BIOS) to assign the system
resources such as IRQ and I/O address to the
ISA PnP device. The default setting is No.
Reset If you enable this item and restart the system,
Configuration any Plug and Play configuration data stored in
Data the BIOS setup is cleared from memory. New
updated data is created.
Resources Under default Auto(ESCD) setting, the system
Controlled by dynamically allocates resources to Plug and
Play devices as they are required. If "Manual"
option is selected, the prompt on the following
line, "IRQ Resources" will become available.
If you can't get a legacy ISA (Industry
Standard Architecture) expansion card to work
properly, you might be able to solve the
problem by changing this item to Manual, and
then opening up the IRQ Resources and
Memory Resources submenus.
38
PnP / PCI Configurations
[No]
Item
[Disabled]
Menu Level
[Auto(ESCD)]
Press Enter
Select Yes if you are
using a Plug and Play
capable operating
[Disabled]
system Select No if
[Enabled]
you need the BIOS to
[Enabled]
configure non-boot
devices
+/-/PU/PD:Value: F10: Save
F6:Fail-Safe Defaults F7:Optimized Defaults
ESC: Exit