What To Do Next; Copying A Configuration File From The Rcp Server To The Device - Cisco Catalyst 9500 Manual

Managing Configuration Files
Booting tokyo-confg from 172.16.2.155:!!! [OK - 874/16000 bytes]

What to Do Next

After you have issued the copy EXEC command, you may be prompted for additional information or for
confirmation of the action. The prompt displayed depends on how much information you provide in the copy
command and the current setting of the file prompt global configuration command.

Copying a Configuration File from the rcp Server to the Device

To copy a configuration file from an rcp server to the running configuration or startup configuration, complete
the following tasks:
SUMMARY STEPS
1. enable
2. configure terminal
3. ip rcmd remote-username username
4. end
5. Do one of the following:
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Device> enable
Step 2 configure terminal
Example:
Device# configure terminal
Step 3 ip rcmd remote-username username
Example:
Device(config)# ip rcmd remote-username NetAdmin1
Step 4 end
Example:
Device(config)# end
• copy rcp:[[[//[username@]location]/directory]/filename]system:running-config
• copy rcp:[[[//[username@]location]/directory]/filename]nvram:startup-config
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
Purpose
Enables privileged EXEC mode.
• Enter your password if prompted.
(Optional) Enters configuration mode from the terminal.
This step is required only if you override the default remote
username (see Step 3).
(Optional) Specifies the remote username.
(Optional) Exits global configuration mode. This step is
required only if you override the default remote username
(see Step 2).
What to Do Next
195