Cisco Catalyst 9500 Manual page 308

Example: Performing a Traceroute to an IP Host
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms
Device#
Table 24: Ping Output Display Characters
Character
!
.
U
C
I
?
&
To end a ping session, enter the escape sequence (Ctrl-^ X by default). Simultaneously press and release the
Ctrl, Shift, and 6 keys and then press the X key.
Example: Performing a Traceroute to an IP Host
This example shows how to perform a traceroute to an IP host:
Device# traceroute ip 192.0.2.10
Type escape sequence to abort.
Tracing the route to 192.0.2.10
1 192.0.2.1 0 msec 0 msec 4 msec
2 192.0.2.203 12 msec 8 msec 0 msec
3 192.0.2.100 4 msec 0 msec 0 msec
4 192.0.2.10 0 msec 4 msec 0 msec
The display shows the hop count, the IP address of the router, and the round-trip time in milliseconds for each
of the three probes that are sent.
Table 25: Traceroute Output Display Characters
Character
*
?
A
H
N
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
294
Description
Each exclamation point means receipt of a reply.
Each period means the network server timed out while waiting for a reply.
A destination unreachable error PDU was received.
A congestion experienced packet was received.
User interrupted test.
Unknown packet type.
Packet lifetime exceeded.
Description
The probe timed out.
Unknown packet type.
Administratively unreachable. Usually, this output means that an access list is blocking traffic.
Host unreachable.
Network unreachable.
Troubleshooting the Software Configuration