Configuring The Client To Download Files From Dhcp Server - Cisco Catalyst 9500 Manual

Performing Device Setup Configuration
Command or Action
Device(config-if)# end

Configuring the Client to Download Files from DHCP Server

Note
You should only configure and enable the Layer 3 interface. Do not assign an IP address or DHCP-based
autoconfiguration with a saved configuration.
SUMMARY STEPS
1. configure terminal
2. boot host dhcp
3. boot host retry timeout timeout-value
4. banner config-save ^C warning-message ^C
5. end
6. show boot
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Device# configure terminal
Step 2
boot host dhcp
Example:
Device(conf)# boot host dhcp
Step 3 boot host retry timeout timeout-value
Example:
Device(conf)# boot host retry timeout 300
Step 4 banner config-save ^C warning-message ^C
Example:
Device(conf)# banner config-save ^C Caution -
Saving Configuration File
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
Configuring the Client to Download Files from DHCP Server
Purpose
Purpose
Enters global configuration mode.
Enables autoconfiguration with a saved configuration.
(Optional) Sets the amount of time the system tries to
download a configuration file.
Note If you do not set a timeout, the system will try
indefinitely to obtain an IP address from the
DHCP server.
(Optional) Creates warning messages to be displayed when
you try to save the configuration file to NVRAM.
65