Examples; What To Do Next - Cisco Catalyst 9500 Manual

Managing Configuration Files
Command or Action
Step 5 Do one of the following:
• copy system:running-config rcp:
[[[//[username@]location ]/directory ]/filename ]
• copy nvram:startup-config rcp:
[[[//[username@]location ]/directory ]/filename ]
Example:
Device# copy system:running-config rcp:
//NetAdmin1@example.com/dir-files/file1

Examples

Storing a Running Configuration File on an RCP Server
The following example copies the running configuration file named runfile2-confg to the netadmin1 directory
on the remote host with an IP address of 172.16.101.101:
Device# copy system:running-config rcp://netadmin1@172.16.101.101/runfile2-confg
Write file runfile2-confg on host 172.16.101.101?[confirm]
Building configuration...[OK]
Connected to 172.16.101.101
Device#
Storing a Startup Configuration File on an RCP Server
The following example shows how to store a startup configuration file on a server by using RCP to copy the
file:
Device# configure terminal
Device(config)# ip rcmd remote-username netadmin2
Device(config)# end
Device# copy nvram:startup-config rcp:
Remote host[]? 172.16.101.101
Name of configuration file to write [start-confg]?
Write file start-confg on host 172.16.101.101?[confirm]
![OK]

What to Do Next

After you have issued the copy EXEC command, you may be prompted for additional information or for
confirmation of the action. The prompt displayed depends on how much information you provide in the copy
command and the current setting of the file prompt global configuration command.
System Management Configuration Guide, Cisco IOS XE Fuji 16.8.x (Catalyst 9500 Switches)
Purpose
• Specifies that the device running configuration file is
to be stored on an RCP server
or
• Specifies that the device startup configuration file is
to be stored on an RCP server
Examples
191