Call Block; Using The Mcall Blockn Button; Storing Unwanted Callers - Panasonic KX-TGF370 Series Operating Instructions Manual

Using the MCALL BLOCKN
button
You can press the MCALL BLOCKN button in
the following situations to disconnect the
current call and add a phone number to the
call block list:
– when an incoming call is being received
– when an incoming call is being recorded by
the answering system
– when talking on an outside call
Once a phone number has been added to the
call block list, the unit will block calls from that
phone number in the future.
Handset
1
Press MCALL BLOCKN under the
situations shown above.
2
Confirm the call block number and press
MYESN.
R The call block number is stored in the
call block list, "Caller blocked" is
displayed, and then the call is
disconnected.
Note:
R If the call has no phone number, the call is
blocked but it is not stored in the call block
list.
R The call block feature is not available:
– for intercom calls or calls received by
Call Waiting.
– when a landline call (or cellular call) is
being received during a cellular call (or
landline call).
R Blocked calls are logged in the caller list.

Storing unwanted callers

The unit can block calls by storing the desired
items in the call block list beforehand (Call
Display subscribers only).
– "Block a single number"
*2
: The unit blocks calls from
a single #"
specific phone numbers stored in the call
block list.
– "Block range of numbers"
*2 : The unit blocks calls that
range of #"
For assistance, visit www.panasonic.ca/english/support
TG175CSK(en)_0324_ver011.pdf
– "Block unknown CID"
*1
*2
Single phone numbers and ranges of numbers
can be stored in the call block list up to 250
items in total.
Blocking unwanted callers:
When a call is received, the unit rings briefly
while caller information is being received.
If the caller's phone number matches an entry
in the call block list, the unit emits no sound to
the caller, and disconnects the call.
*1
Storing a single phone number
Important:
R We recommend storing 10 digits (including
Adding call blocked numbers from
the caller list
Handset
n When a cellular phone is paired:
*1
/"Block
*1 /"Block
31
begin with a number stored in the call block
list, such as a toll-free phone number prefix
or certain area codes.
*1
*2
: The unit blocks calls that
unknown"
have no phone number.
Handset
Base unit
If you do not want this one ring to sound,
select "No" in "Setting not to ring once for
blocked call" (page 33).
the area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
1
MCN CID
2
MbN: Select the desired entry to be
blocked.
R To edit the number:
MSELECTN a Press * (Edit)
repeatedly until the phone number
is shown in the 10-digit format. a
MSAVEN a MbN "Call block" a
MSELECTN a Go to step 4.
3
MCALL BLOCKN
4
MbN: "Yes" a MSELECTN
5
Edit the phone number if necessary
(24 digits max.).

Call Block

/"Block
*1
31
2016/03/24 9:06:19