Using A Bluetooth Wireless Headset (Optional) For Landline Calls - Panasonic KX-TGF370 Series Operating Instructions Manual

Using Bluetooth® Devices
– "Off": Voice announcement is not
available as alert.
You can configure this setting using either the
base unit or one of the handsets.
Handset / Base unit
1
For CELL 1: MMENUN#6031
For CELL 2: MMENUN#6032
2
MbN: Select the desired setting. a
MSAVEN
3
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Selecting the alert tone
Handset
1
For CELL 1: MMENUN#6041
For CELL 2: MMENUN#6042
2
MbN: Select the desired setting.
3
MSAVEN a MOFFN
Temporary alert off
You can temporarily disable the alerts by
pressing MAPP ALERTSN.
Base unit
Press MAPP ALERTSN to temporarily disable
alerts.
R is displayed.
R To enable alerts again, press MAPP
ALERTSN again.
Using a Bluetooth wireless
headset (optional) for
landline calls
By pairing a Bluetooth headset to the base
unit, you can have a hands-free conversation
wirelessly for landline calls.
Important:
R Your Bluetooth wireless headset must
support the HeadSet Profile (HSP)
specification.
R 1 headset can be paired to the base unit.
For assistance, visit www.panasonic.ca/english/support
60
TG175CSK(en)_0324_ver011.pdf
R Only 2 Bluetooth devices can be used with
R For best performance, we recommend
Pairing a headset to the base unit
Important:
R Make sure that the Bluetooth headset is not
1
2
3
4
5
Connecting/disconnecting a headset
If you cannot connect the headset and base
unit using the headset, you can connect using
the handset.
To use your headset with another Bluetooth
device such as a cellular phone, you may
need to disconnect it from the base unit.
Important:
R Make sure that the headset is turned on.
Handset
1
60
the unit at the same time (for example, 2
cellular lines, or the headset and 1 cellular
line).
using a Bluetooth headset within 1 m
(3.3 feet) of the base unit. A headset can
communicate with the base unit within a
range of approximately 10 m (33 feet).
connected to any other Bluetooth device.
Your headset:
Set your headset to pairing mode.
R Refer to the headset operating
instructions.
Handset:
MMENUN#621
If your headset PIN is "0000", go to
step 4.
If your headset PIN is other than
"0000", press MCLEARN, then enter your
headset PIN.
R Typically, default PIN is "0000". Refer
to the headset operating instructions.
Press MOKN, then wait until a long beep
sounds.
MOFFN
R When is displayed on the base
unit, the headset is available for use.
To connect/disconnect:
MMENUN#622
2016/03/24 9:06:21