Call Block; Storing Unwanted Callers - Panasonic KX-TGF973 Operating Instructions Manual

Call Block

Call block
n Pre-installed block list:
The unit can block calls when receiving the
call from the phone number in
pre-programmed call block list (14,000 items).
Database is supplied by YouMail Inc..
n Manual call block:
You can press the MCALL BLOCKN button in
the following situations to disconnect the
current call and add a phone number to the
call block list:
– when an incoming call is being received
– when an incoming call is being recorded by
the answering system
– when talking on an outside call
Once a phone number has been added to the
call block list, the unit will block calls from that
phone number in the future.
Handset / Base unit
1
Press MCALL BLOCKN under the
situations shown above.
2
Confirm the call block number and press
MYESN.
R The call block number is stored in the
call block list, confirmation tone
*1
sounds and "Call blocked" is
displayed, and then the call is
disconnected.
*1 Confirmation tones are used with
permission of © 2018 Copyrights Vision
Inc.
Note:
R If the call has no phone number, the call is
blocked but it is not stored in the call block
list.
R The call block feature is not available:
– for intercom calls or calls received by call
waiting.
– when a landline call (or cellular call) is
being received during a cellular call (or
landline call).
R Blocked calls are logged in the caller list.
For assistance, please visit http://shop.panasonic.com/support
38
KX-TGF97xUSA(en-us)_0928_ver121.pdf 38

Storing unwanted callers

The unit can block calls by storing the desired
items in the call block list beforehand (Caller
ID subscribers only).
– "Single number" *1 /"Single #"
unit blocks calls from specific phone
numbers stored in the call block list.
– "Range of numbers"
*2
: The unit blocks calls that begin with a
#"
number stored in the call block list, such as
a toll-free phone number prefix or certain
area codes.
– "Block unknown CID"
*2
: The unit blocks calls that
unknown"
have no phone number.
*1 Handset
*2 Base unit
Single phone numbers and ranges of numbers
can be stored in the call block list up to 2,000
items in total.
Blocking unwanted callers:
When a call is received, the unit will not ring
while caller information is being received.
If the caller's phone number matches an entry
in the call block list, the unit emits no sound to
the caller, and disconnects the call.
*1 If you want the first ring to sound, select
"Yes" in "Turning the first ring on/off"
(page 40).
Storing a single phone number
Important:
R We recommend storing 10 digits (including
the area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
Adding call blocked numbers from
the caller list
Handset
n When a cellular phone is paired:
1
MCN CID
*2 : The
*1
/"Range of
*1
/"Block
*1
9/28/2022 11:24:40 AM