Panasonic KX-TGF370 Series Operating Instructions Manual page 18

Link to Cell
Auto connection to the Bluetooth
devices (cellular phones)
After pairing, your Bluetooth devices are
connected to the base unit. If you move the
Bluetooth devices out of base unit range, the
Bluetooth devices are disconnected from the
base unit. This feature allows the base unit to
try to reconnect the Bluetooth devices at
regular intervals when it returns within base
unit range. You can set the interval. The
default setting is "1 min".
Important:
R When 3 Bluetooth devices (2 cellular
phones and 1 headset) are paired to the
base unit, only 2 Bluetooth devices can be
used with the unit at the same time, and the
base unit loses its connection from other
Bluetooth devices. To automatically resume
the connection to Bluetooth devices, leave
the auto connection on.
R Some cellular phones lose connection after
usage, please check the specifications of
your cellular phone for more details.
Handset
1
MMENUN#632
2
MbN: Select the desired setting.
3
MSAVEN a MOFFN
Note:
R Some cellular phones may ask you if you
accept the connection requirement from the
base unit. In that case, select "Off" in step
2. Check the specifications of your cellular
phone.
Connecting/disconnecting the
cellular phone manually
If you will not be using the paired cellular
phone's link to cell feature temporarily (for
example, you do not want the unit to ring
when your cellular line receives a call), you
can disconnect your cellular phone from the
base unit. If you want to use it again,
reconnect the cellular phone to the base unit.
For assistance, visit www.panasonic.ca/english/support
18
TG175CSK(en)_0324_ver011.pdf
Note:
R After you disconnect a paired cellular
R A disconnected cellular phone is not
Handset
1
2
Cellular line only mode (If you do
not use the landline)
If you do not use the landline, we recommend
setting the unit to the cellular line only mode.
The default setting is "Off".
Important:
R If you turn on the "Cell line only
Handset
1
2
Note:
R Once you set this mode, you can use the
R Once you set this mode, the following
18
phone from the base unit manually, it will
automatically be connected to the base unit
in 30 minutes. If you do not use the link to
cell feature anymore, unpair the cellular
phone (page 18).
unpaired from the base unit, so pairing it to
the base unit again is unnecessary.
To connect/disconnect:
For CELL 1: MMENUN#6251
For CELL 2: MMENUN#6252
R A long beep sounds.
MOFFN
mode", disconnect the telephone line cord
from the base unit. Otherwise the "Cell
line only mode" cannot be activated.
MMENUN#157
To turn on:
MbN: "On" a MSELECTN a MbN: "Yes"
a MSELECTN
To turn off:
MbN: "Off" a MSELECTN
following buttons to make cellular calls:
– for the handset, press M
instead of MCELLN (page 20).
– for the base unit, press MZN without
pressing MCELL 1N or MCELL 2N set for
the cellular line selection (page 19,
26).
features cannot be used:
N or MZN
2016/03/24 9:06:19