Link To Cell Settings - Panasonic KX-TGF370 Series Operating Instructions Manual

2
MbN: "Yes" a MSELECTN
R When the cellular phone is unpaired,
the CELL indicator is turned off.
3
MOFFN

Link to cell settings

Selecting which unit receives
cellular calls
You can select which unit rings and receives
calls for a cellular line. When "All" is
selected, all handsets and the base unit ring.
Handset
1
For CELL 1: MMENUN#6271
For CELL 2: MMENUN#6272
2
MbN: Select the desired handset or "All".
a MSAVEN
3
MOFFN
Note:
R When you select a specific handset to
receive calls for a cellular line:
– other handsets cannot answer the calls.
– the base unit can answer the calls even
though it does not ring. However, you
can make the base unit ring by adjusting
the base unit ringer volume (page 46).
R When you change to "All" from another
setting, the base unit ringer volume also
returns to the lowest level even if the ringer
volume was changed.
R The units selected with this setting have the
alert feature (page 59) applied to them.
Ring as cell mode
Once this feature is turned on, the handset
and base unit ring using the same ringer tone
as your cellular phone.
The following settings are available:
– "Off": Turn this feature off to use the
ringer tones of the handset and base unit.
Caller information is announced depending
on the Talking Call Display setting
(page 43).
For assistance, visit www.panasonic.ca/english/support
TG175CSK(en)_0324_ver011.pdf
– "On (with Talking CID)" (default):
– "On (without Talking CID)": The
Important:
R To use this feature, your cellular phone
Handset
1
2
3
Note:
R The units use the preset ringer tones
R If your cellular phone is in night mode with
To use the handset ringer tone
instead of your cellular phone's
ringer tone
Select "Off" in step 2, "Ring as cell mode",
page 17.
To change the handset ringer tone for a
cellular line, see page 41.
17
The handset and base unit use your cellular
phone's ringer tone. Caller information is
announced even if the Talking Call Display
is turned off.
handset and base unit use your cellular
phone's ringer tone. Caller information is
not announced even if the Talking Call
Display is turned on.
must support Bluetooth in-band ringtone.
Refer to your cellular phone's operating
instructions.
For CELL 1: MMENUN#6141
For CELL 2: MMENUN#6142
MbN: Select the desired setting.
MSAVEN a MOFFN
instead of your cellular phone's ringer tone
when a cellular call is being received if:
– your cellular phone is in night mode
(depending on your cellular phone).
– the base unit is in use.
– 2 handsets are sharing a landline call.
"On (with Talking CID)" set, the unit
announces caller information even when
Talking Call Display is turned off
(page 43).
Link to Cell
17
2016/03/24 9:06:19