Remote Operation - Panasonic KX-TGF370 Series Operating Instructions Manual

Answering System for Landline
Erasing the set phone number
Handset
1
MMENUN#338
2
MbN: "Notification to" a MSELECTN
3
MMENUN a MbN: "Erase" a MSELECTN
4
MbN: "Yes" a MSELECTN a MOFFN
R The new message alert setting is
turned off.
Activating/inactivating the remote
access code to play messages
If you activate this feature, you must enter the
remote access code (page 66) to play the
new message from the new message alert
call. This is so that unauthorized parties
cannot listen to your messages. The default
setting is "Inactivate".
– "Inactivate": You can listen to the
message by pressing 4 to play new
messages (without entering the remote
access code).
– "Activate": You must enter your remote
access code and then press 4 to play new
message.
Handset
1
MMENUN#338
2
MbN: "Remote code" a MSELECTN
3
MbN: Select the desired setting. a
MSAVEN a MOFFN
Listening to messages
After you answer the new message alert, you
can listen to the messages as follows.
n When the remote access code is set to
"Inactivate":
Press 4 to play the new message during
the announcement.
n When the remote access code is set to
"Activate":
1
Enter the remote access code
(page 66) during the announcement.
2
Press 4 to play the new message.
For assistance, visit www.panasonic.ca/english/support
66
TG175CSK(en)_0324_ver011.pdf
Note:
R Within 10 seconds after listening to new
R Even if the unit makes a new message alert

Remote operation

Using a touch-tone phone, you can call your
phone number from outside and access the
unit to listen to messages or change
answering system settings. The unit's voice
guidance prompts you to press certain dial
keys to perform different operations.
Remote access code
A 3-digit remote access code must be entered
when operating the answering system
remotely. This code prevents unauthorized
parties from listening to your messages
remotely. The default setting is "111".
Important:
R To prevent unauthorized access to this
Handset
1
2
3
Deactivating remote operation
Press * in step 2 on "Remote access code",
page 66.
R The entered remote access code is deleted.
66
messages, you can press #9 during the
call to turn off the new message alert by a
call feature.
call, the handset redial list does not show
the record. However, on the base unit redial
list it is shown as "Message alert".
product, we recommend that you regularly
change the remote code.
MMENUN#306
Enter the desired 3-digit remote access
code.
MSAVEN a MOFFN
2016/03/24 9:06:21