Link To Cell Settings - Panasonic KX-TGE262C Operating Instructions Manual

Link to Cell

Link to cell settings

Selecting which unit receives
cellular calls
You can select which unit rings and receives
calls for a cellular line. When "All" is
selected, all handsets and the base unit ring.
1
For CELL 1: MMENUN#6271
For CELL 2: MMENUN#6272
2
MbN: Select the desired handset or "All".
a MSAVEN
3
MOFFN
Note:
R When you select a specific handset to
receive calls for a cellular line:
– other handsets cannot answer the calls.
– the base unit can answer the calls even
though it does not ring. However, you
can make the base unit ring by adjusting
the base unit ringer volume (page 38).
(KX-TG465SK series: page 3)
R When you change the setting to "All", the
base unit ringer volume also returns to the
lowest level even if the ringer volume has
been changed.
R The units selected with this setting have the
text message alert feature (page 52)
applied to them.
Ring as cell mode
Once this feature is turned on, the handset
and base unit ring using the same ringer tone
as your cellular phone.
The following settings are available:
– "Off": Turn this feature off to use the
ringer tones of the handset and base unit.
Caller information is announced depending
on the Talking Call Display setting
(page 40).
– "On (with Talking CID)" (default):
The handset and base unit use your cellular
phone's ringer tone. Caller information is
announced even if the Talking Call Display
is turned off.
– "On (without Talking CID)": The
handset and base unit use your cellular
18
TGE26x_27xC(en)_1224_ver012.pdf
phone's ringer tone. Caller information is
not announced even if the Talking Call
Display is turned on.
Important:
R To use this feature, your cellular phone
must support Bluetooth in-band ringtone.
Refer to your cellular phone's operating
instructions.
1
For CELL 1: MMENUN#6141
For CELL 2: MMENUN#6142
2
MbN: Select the desired setting.
3
MSAVEN a MOFFN
Note:
R The units use the preset ringer tones
(page 40) instead of your cellular phone's
ringer tone when a cellular call is being
received if:
– your cellular phone is in night mode
– the base unit is in use.
– 2 handsets are sharing a landline call.
R If your cellular phone is in night mode with
"On (with Talking CID)" set, the unit
announces caller information even when
Talking Call Display is turned off
(page 40).
To use the handset ringer tone
instead of your cellular phone's
ringer tone
Select "Off" in step 2, "Ring as cell mode",
page 18.
To change the handset ringer tone for a
cellular line, see page 38.
Auto connection to the Bluetooth
devices (cellular phones or
headset)
After pairing, your Bluetooth devices are
connected to the base unit. If you move the
Bluetooth devices out of base unit range, the
Bluetooth devices are disconnected from the
base unit. This feature allows the base unit to
try to reconnect the Bluetooth devices at
regular intervals when it returns within base
18
(depending on your cellular phone).
2013/12/24 15:43:29