Link To Cell Settings - Panasonic KX-TGF373 Operating Instructions Manual

Link to Cell
2
MbN: "Yes" a MSELECTN
R When the cellular phone is unpaired,
the CELL indicator is turned off.
3
MOFFN

Link to cell settings

Selecting which unit receives
cellular calls
You can select which unit rings and receives
calls for a cellular line. When "All" is
selected, all handsets and the base unit ring.
Handset
1
For CELL 1: MMENUN#6271
For CELL 2: MMENUN#6272
2
MbN: Select the desired handset or "All".
a MSAVEN
3
MOFFN
Note:
R When you select a specific handset to
receive calls for a cellular line:
– other handsets cannot answer the calls.
– the base unit can answer the calls even
though it does not ring. However, you
can make the base unit ring by adjusting
the base unit ringer volume (page 47).
R When you change to "All" from other
setting, the base unit ringer volume also
returns to the lowest level even if the ringer
volume was changed.
R The units selected with this setting have the
alert feature (page 59) applied to them.
Ring as cell mode
Once this feature is turned on, the handset
and base unit ring using the same ringer tone
as your cellular phone.
The following settings are available:
– "Off": Turn this feature off to use the
ringer tones of the handset and base unit.
Caller information is announced depending
on the Talking Caller ID setting (page 44).
For assistance, please visit www.panasonic.com/support
18
TGF37x(en)_1128_ver032.pdf
– "On (with Talking CID)" (default):
– "On (without Talking CID)": The
Important:
R To use this feature, your cellular phone
1
2
3
Note:
R The units use the preset ringer tones
R If your cellular phone is in silent mode with
To use the handset ringer tone
instead of your cellular phone's
ringer tone
Select "Off" in step 2, "Ring as cell mode",
page 18.
To change the handset ringer tone for a
cellular line, see page 42.
Auto connection to the Bluetooth
devices (cellular phones)
After pairing, your Bluetooth devices are
connected to the base unit. If you move the
18
The handset and base unit use your cellular
phone's ringer tone. Caller information is
announced even if the Talking Caller ID is
turned off.
handset and base unit use your cellular
phone's ringer tone. Caller information is
not announced even if the Talking Caller ID
is turned on.
must support Bluetooth in-band ringtone.
Refer to your cellular phone's operating
instructions.
Handset
For CELL 1: MMENUN#6141
For CELL 2: MMENUN#6142
MbN: Select the desired setting.
MSAVEN a MOFFN
instead of your cellular phone's ringer tone
when a cellular call is being received if:
– your cellular phone is in silent mode
(depending on your cellular phone).
– the base unit is in use.
– 2 handsets are sharing a landline call.
"On (with Talking CID)" set, the unit
announces caller information even when
Talking Caller ID is turned off (page 44).
2014/11/28 16:08:39