Table of Contents
Advertisement
The antistatic pathway is: Mattress Pad →Tabletop →Column →Base →Floor Lock
Pads →Floor. Therefore, the anti-static properties of the table depend upon the use of
the recommended mattress pads.
Le chemin antistatique est le suivant: Couvre-matelas→ dessus de Table→ Colonne→
Base→ Patins de verrouillage au sol→Plancher. Par conséquent, les propriétés
antistatiques de la table dépendent de l'utilisation des couvre-matelas recommandés par
NUVO.
4.3 .1 B2AV800LSK and B2AV800LS
1 Press the Lock button (#2, Figure 5-2) of Hand Pendant and wait for the green LED to
light up, the floor locks will become locked. The table will remain locked until the
unlock button (#8, Figure 5-2) is pressed.
2 Make sure the table does not wobble. If the table does not wobble it means the locks
are snug against the floor.
Note:
If the hand pendant's service LED becomes lit and the base panel's 10-segment LED
indicator displays the service code for over-voltage or under-voltage, please refer to
Section 4.7 to adjust the voltage, and then come back to finish the table lock
procedure.
Remarque: Si le voyant de service du boîtier de commande manuelle s'allume et que l'indicateur
à 10 segments du panneau de base affiche le code de service relatif à une
surtension ou une sous-tension, veuillez vous référer à la section 4.7 pour ajuster la
tension, puis revenez pour terminer la procédure de verrouillage de la table.
4.3 .2 B2AV800SK, B2AV800S, B2AV800K and
B2AV800
1. After placing the table in the desired location, step
on the pedal to lock the table.
2. If the table wobbles, use a 32mm wrench to turn
the screw to adjust floor lock height.
CAUTION! MISE EN GARDE!
Figure 4-3:
4-4
B2AV800 Series Surgical Table
IM-B2AV800-E01
Advertisement
Table of Contents
