2.1.1 Mounting The Device On A Din Rail; Mounting The Device To A Panel - Siemens SIMATIC NET RUGGEDCOM RS950G Installation Manual

Installing the Device
2.1.1 Mounting the Device on a DIN Rail
Note
For detailed dimensions of the device with either DIN rail or panel hardware installed,
refer to
2.1.1 Mounting the Device on a DIN Rail
For DIN rail installations, the RUGGEDCOM RS950G can be ordered with a DIN rail
mounting bracket pre-installed on the rear of the chassis. The bracket allow the
device to be slid onto a standard 35 mm (1.4 in) DIN rail.
IMPORTANT
DIN rail mounting is not recommended for constant vibration environments.
To mount the device to a DIN rail, do the following:
1.
2.
2.1.2

Mounting the Device to a Panel

For panel installations, the RUGGEDCOM RS950G can be ordered with mounting
brackets that mount to the top and bottom of the chassis.
To mount the device to a panel, do the following:
1.
8
"Dimension Drawings (Page
Pull the DIN rail adapter down and clip the device on to the DIN rail. Release the
adapter to secure the device.
1
DIN Rail
1
DIN Rail Mounting Bracket
2
Figure 2.1 DIN Rail Mounting
Slide the device into position.
Remove the bracket mounting screws from the top and bottom of the chassis.
23)".
Installation Manual, 01/2021, C79000-G8976-1037-06
1
2
RUGGEDCOM RS950G