CPI INDICO 100 Series Operator's Manual page 53

CPI Canada Inc
CLEANING
Indico 100 Series Operator Manual
• Never use anything other than soap and water to clean plastic
surfaces. Other cleaners may damage the plastic.
• Never use any corrosive, solvent or abrasive detergents or
polishes.
• Ensure that no water or other liquid can enter any equipment. This
precaution prevents
components.
• Methods of disinfection used must conform to legal regulations and
guidelines regarding disinfection and explosion protection.
• If disinfectants are used which form explosive mixtures of gases, these
gases must have evaporated before switching on the equipment again.
• Disinfection by spraying is not recommended because the disinfectant
may enter the X-ray equipment.
• If room disinfection is done with an atomizer, it is recommended that
the equipment be switched OFF, allowed to cool down and covered
with a plastic sheet. When the disinfectant mist has subsided, the
plastic sheet may be removed and the equipment be disinfected by
wiping.
740953-00
short circuits and
Rev. A
Maintenance Schedule
corrosion forming on
Page 53
8