CPI INDICO 100 Series Operator's Manual page 41

CPI Canada Inc
ERROR CODE
E036
E037
E038
E039
E040
E041
E042
E043
E044
E045
E046
E047
E048
E049
E050
E051
E052
E053
E054
E055
Indico 100 Series Operator Manual
MESSAGE
+15VDC ERROR
-15VDC ERROR
CAL DATA ERROR
AEC DATA ERROR
FLUORO DATA ERROR
REC DATA ERROR
TUBE DATA ERR
KV ERROR
COMM ERROR
NOT SUPPORTED
MODE INHIBITED
FL TIMER LIMIT
FOCUS MISMATCH
NOT ENABLED
GEN DATA ERROR
AEC DEVICE ERR
HIGH SF CURRENT
HIGH LF CURRENT
AEC OUT OF RANGE
NO FIELDS ACTIVE
740953-00
Error Codes and Messages
PROBLEM
Received communication
message not valid and
ignored.
Received message valid,
but not supported by this
system.
Received message valid,
but not allowed during
present state.
Fluoro Timer has exceeded
time limit.
Requested function has not
been programmed to be
enabled.
Generator has detected no
feedback signal from AEC
device.
AEC enabled but no fields
are selected.
Rev. A
6
ACTION
Consult your service
representative.
Consult your service
representative.
Consult your service
representative.
Consult y our service
representative.
Consult your service
representative.
Consult your service
representative.
Consult your service
representative..
Switch OFF generator.
Prevent further use of
generator, then.
consult your service
representative.
Reset error.
Reset error.
Reset error.
Reset Fluoro timer.
Consult your service
representative.
Consult your service
representative.
Consult your service
representative.
Check that X-ray tube
is pointing at correct
AEC device.
Consult your service
representative.
Consult your service
representative.
Consult your service
representative.
Consult your service
representative.
Select AEC field(s).
Page 41