Magiqcool Controller Settings; Manual Mode; Auto Mode; Magiqcool Controller Operation - Seeley LCQ Owner's Manual

MAGIQCOOL CONTROLLER
SETTINGS
MagIQcool Wall Controllers can operate in
manual or automatic mode.

Manual mode

Manual mode will allow you to change settings
for operating the cooler, such as altering
fan speeds, pump control and manual drain
control.

Auto mode

Auto mode will allow thermostatic control to set
temperature targets / operating settings. It has
the capability of programming ON/OFF delay
times, enabling the cooler to automatically
start up or shut down after a specified period
of hours.
At all times the MagIQcool Controller will
monitor the cooler for faults and report them to
the controller's screen for your reference.

Turning the Cooler On

The wall control can be switched on and off by
pressing the button. The wall control
will remember the previous setting it was in
when the cooler was last used.

Preparing to Start

Whenever you select AUTO mode or COOL
in MANUAL mode, the cooler will take a
few minutes to start as it fills with water and
saturates the cooling pads. The time will be
decreased if the tank is full or the cooler has
only recently been turned OFF.
During this time "Preparing to Start" will flash
on the display.
|
2
MAGIQCOOL CONTROLLER
OPERATION
Manual Mode
With the wall control switched ON,
press the
on the display.
You may then press the
switch between COOL and VENT (where fresh
air is being delivered but not cooled).
Once COOL or VENT has been selected, the
wall control will maintain a constant fan speed.
This is indicated by the bar graph shown on
the display.
To increase or decrease the fan speed
required, press either the
button.
Auto Mode
To select the AUTO mode press the
button until AUTO is shown on the display.
ILL2121-A
In AUTO mode the cooler will remember the
last setting used. Press the
you require more cool air or the
if you require less. Don't alter the setting
however, until the room temperature has
stabilised.
button until MAN is shown
ILL1122-A
button to
ILL1123-B
or
ILL1124-A
button if
button