Table of Contents
Advertisement
M1110 Mill with Dovetail Column
Replacing Motor Brushes
After some period of time, the carbon brushes on the
DC motor will need to be replaced. Always replace the
brushes in pairs. Use part # XM11102242.
To replace the motor brushes, do these steps:
1. DISCONNECT THE MILL FROM POWER!
2. Remove and replace the spring and carbon brush as
shown in Figure 34.
Note: A 10 Amp fuse is housed in the body near the
main controls.
Replacing Main Fuse
Should a fuse ever blow, do not replace the 10 amp fuse
with a fuse rated for a higher amp rating. Doing so will
damage the circuit board and void the warranty. Refer to
Troubleshooting or call Woodstock International Technical
Support for a solution.
To replace the fuse, do these steps:
1. DISCONNECT THE MILL FROM POWER!
2. Remove and replace the fuse from the fuse cradle,
as shown in Figure 35.
Carbon Brush
Figure 34. Carbon brush removal.
Figure 35. Fuse replacement.
-29-
Advertisement
Table of Contents
