DataLoop™ LI25 Level Controller
RESET METER TO FACTORY DEFAULTS
When the parameters have been changed in a way that is difficult to determine
what's happening, it might be better to start the setup process from the factory
defaults.
Instructions to load factory defaults:
1.
Enter the Advanced features menu by holding the Menu button for 5
seconds. Press Up arrow until info is shown.
2.
Press and hold Right arrow/Reset for five seconds, press
Enter/Ack when display flashes reset.
Note: If Enter/Ack is not pressed within three seconds, display returns to
Information menu.
3.
The meter goes through an initialization sequence (same as on power-up),
and loads the factory default settings.
34
Instruction Manual
MN301034 rev D