DataLoop™ LI25 Level Controller
CONNECTIONS
Signal connections are made to a four-terminal removable connector. This section
is only intended for the LI25-1001.
LI25-2001 installation must be performed in accordance with Control
Drawing QS301034-1 in order to meet agency approval ratings.
S+ S- B+ B-
10
Observe all safety regulations. Electrical wiring should be
performed in accordance with all agency requirements
and applicable national, state, and local codes to prevent
damage to the meter and ensure personnel safety.
Figure 2. LI25 Series Rear View
Instruction Manual
MN301034 rev D