Table of Contents
Advertisement
LI25 Series Loop-Powered Meters
Reset Meter to Factory Defaults
When the parameters have been changed in a way that is difficult to
determine what's happening, it might be better to start the setup
process from the factory defaults.
Instructions to load factory defaults:
1.
Enter the Advanced features menu. See Advanced Features Menu,
page 25.
2.
Press Up arrow until info is shown.
3.
Press and hold Right arrow/Reset for five seconds, press
Enter/Ack when display flashes reset.
Note: If Enter/Ack is not pressed within three seconds, display
returns to Information menu.
4.
The meter goes through an initialization sequence (same as on
power-up), and loads the factory default settings.
Press and Hold for 5 Sec
info
Press and Hold
for 3 Sec
Flashing
Display
reset
34
Instruction Manual
Meter Re-
Initializes
Advertisement
Table of Contents
