Maximum & Minimum (Max & Min) - FlowLine DataLoop LI25 Series Instruction Manual

DataLoop™ LI25 Level Controller
Maximum & Minimum Readings
The maximum and minimum (peak & valley) readings reached by the process
are stored in the meter since the last reset or power-up. The meter shows MIN or
MAX to differentiate between run mode and max/min display.
1. Press Up arrow/Max button to display maximum reading since the last
reset/power-up.
2. Press Up arrow/Max again to display the minimum reading since the last
reset/power-up.
3. Press Enter/Ack to hold Max/Min display reading, the meter will continue to
track new Max/Min readings.
4. If Enter/Ack is not pressed, the Max/Min display reading will time out after
ten seconds and the meter will return to display the actual reading.
5. Press Right arrow/Reset button to reset Max/Min while reading is being
displayed. Max/Min display readings are reset to actual reading.
32
(Max& MiN)
Instruction Manual
MN301034 rev D