LI25 Series Loop-Powered Meters
Connections
Signal connections are made to a four-terminal removable connector. This
section is only intended for the LI25-1001.
LI25-2001 installation must be performed in accordance with
Control Drawing QS301034-1 in order to meet agency approval
ratings.
!
S+ S- B+ B-
Observe all safety regulations. Electrical wiring
should be performed in accordance with all agency
requirements and applicable national, state, and
local codes to prevent damage to the meter and
ensure personnel safety.
Figure 2. LI25 Series Rear View
11
Instruction Manual