Measurements And Adjustments - Panasonic NE-SCV2BPQ Service Manual

NE-SCV2BPQ

13 Measurements and Adjustments

13.1. Oven output measurement
If we heat 1 liter of water in P7 (the oven 900W) for one minute and we let T 1 °C be the water temperature before heating and let T
2 °C be the one after heating, the output (W) is obtained from the following equation.
Output (W) = (T 2 - T 1) x 70 = T x 70
Load
1 L of water
13.2. Adjustment of hinge and latch
Check the operation for each switch after disassembly, assembly and replacement of parts for door and latch switch.
• If an operational failure occurs on door switch, door signal switch and short switch, perform the adjustment outlined below.
1. Adjustment of hinge
Close the door, fit the hinge on the front of oven and tighten the hinge attachment screw.
2. Adjustment of latch switch bracket
a. Close the door, loosen the attachment screw for each latch switch bracket, slide the bracket back and forth to adjust latch
switch lever and door hook A/B as pressing against the actuator of each switch.
b. Check the operation for door opening and closing and each switch.
Measurement time Output tolerance (W)
1 minute 810 to 1035
74
Water temperature rise value (°C)
11.5 to 14.8