Panasonic NE-SCV2BPQ Service Manual page 69

12.15. Door Switch / Short Switch /
Door Signal Switch
1. Remove the Cabinet. (See "12.1 Cabinet")
2. Open the door.
3. Disconnect each connector.
4. Remove the switches from the mounting plate. (Black
arrows: 2 tabs each)
12.16. Circulation Fan Case U
1. Remove the Back plate. (See 12.2. "Back Plate")
2. Disconnect the connectors from each Thermal cutout. (2
places each)
3. Disconnect the connector for the Circulation fan motor. (1
place)
4. Remove the grounding screw. (Black arrow: 1 screw)
5. Disconnect the connectors from each Thermal cutout. (2
places each)
6. Remove the connector (CN41) for the PC board, the relay
connectors (2 places), and the lead wire screws (2
places).
• Disengage the lead wire (oven thermistor) of the
removed connector (CN41) from each holder.
7. Remove the Air guide G. (Black arrows: 3 screws; White
arrow: 1 tab)
8. Remove the Air guide D. (2 screws)
69
NE-SCV2BPQ