Panasonic NE-SCV2BPQ Service Manual page 72

NE-SCV2BPQ
12.20. Exhaust Thermistor
1. Remove the Back plate. (See 12.2. "Back Plate")
2. Disconnect the connector (CN40) for the PC board.
• Disengage the disconnected lead wire from each holder.
3. Remove the Exhaust thermistor. (2 screws)
• To remove it, spread the adiabatic materials at the
location where it is installed.
* During assembly, be careful not to pinch the adiabatic
materials.
12.21. Thermal Cutout (for Top
Heater)
1. Remove the Cabinet. (See "12.1 Cabinet")
2. Disconnect the connectors from each Thermal cutout.
3. Remove each Thermal cutout. (Black arrow: 1 screw
each; White arrow: 1 tab each)
12.22. Thermal Cutout (for Rear
Heater)
1. Remove the Back plate. (See 12.2. "Back Plate")
2. Disconnect the connectors from each Thermal cutout.
3. Remove each Thermal cutout. (2 screws each)
72