Measurements And Adjustments - Panasonic NN-G335MF Service Manual

IMPORTANT NOTICE
1.The following components have potentials above
2000V while the appliance is operated.
* Magnetron
* High voltage transformer
* High voltage diode
* High voltage capacitor
Pay special attention to these areas.
2.When the appliance is operated with the door
hinge or magnetron adjusted incorrectly, the
microwave leakage can exceed more than 5mW/cm
. After repair or exchange, it is very important to
2
check that magnetron and the door hinge is
correctly installed.

3. MEASUREMENTS AND ADJUSTMENTS

3.1. Adjustment of Primary latch switch, Secondary latch switch and
Short switch.
1. Mount the Primary latch swith, the Secondary latch switch and the
Short switch to the door hook assembly as shown in ILL.
NOTE:
No specific individual adjustments during installation of the
Primary latch switch, Secondary latch switch or Short switch to
the door hook are required.
2. When mounting the door hook assembly to the oven assembly,
adjust the door hook assembly by moving it in the direction of the
arrows in the illustration so that the oven door will not have any
play in it. Check for play in the door by pulling the door assembly.
Make sure that the latch keys move smoothly after adjustment is
completed. Completely tighten the screws holding the door hook
assembly to the oven assembly.
3. Reconnect the short switch and check the coninuity of the
monitor circuit and all latch switches again by following the
component test procedures.
8