12.7. MAG thermistor
1. Remove the Back plate. (See 12.2. "Back Plate")
2. Disconnect the connector (CN42) for the PC board.
• Disengage the disconnected lead wire from each holder.
3. Remove each Magnetron. (See 12.6. "Magnetron")
4. Remove each MAG thermistor. (1 screw each)
12.8. Antenna Motor
1. Remove Cover B. (See 12.3 "Cover C / Cover B")
2. Disconnect the connector.
3. Remove Antenna Motor Bracket. (Black arrows: 2
screws)
4. Remove Antenna Motor. (White arrows: 2 screws)
12.9.
Operation Panel U
1. Remove the Cabinet. (See "12.1 Cabinet")
2. Disconnect the connector (CN3) for the PC board.
3. Remove the Upper sash. (Black arrows: 3 screws; White
arrows: 2 screws)
4. Remove the Operation panel U. (Black arrow: 1 screw;
White arrow: 1 screw; Diagonally shaded arrow: 1 screw;
4 tabs)
65
NE-SCV2BPQ