Installation Of The Intake Silencer With Integrated Airfilter - Rotax 125 senior MAX evo Installation Manual

INSTALLATION OF THE INTAKE
SILENCER WITH INTEGRATED
AIRFILTER
Procedure
Step
1 Install the rubber intake pipe (pos. 5)
in a vertical position into the bottom
half (pos. 2) of the intake silencer so
that the rounded intake openings point
outwards.
2 Fit the carburetor socket (pos. 6) into
the top half of the intake silencer case
(pos. 1) so that the arrow on the socket
points towards the carburetor.
3
Install the filter element (pos. 3) with
holders (pos. 4) into the bottom half of
intake silencer (pos. 2).
4 Assemble bottom half of intake si-
lencer case (pos. 2) with top half (pos.
1) as shown in the following figure.
Make sure that the locking is inter-
locked properly.
5 Attach the intake silencer with the sup-
plied hose clamp (pos. 11) to the
carburetor.
NOTE
The carburetor socket (pos. 6) is asymmetrical
and can be turned so that the best possible po-
sition between carburetor and intake silencer
can be achieved.
Step Procedure
6 Attach the intake silencer on the sup-
port bracket (pos. 8) using 2 Allen
screws M6x20 (pos. 10) with washers
(pos. 9) and nuts (pos. 7).
4
Page 6
Edition: March 01 2021
BRP-Rotax
INSTALLATION INSTRUCTION
Effectivity: 125 MAX evo, Junior MAX
evo, Mini MAX evo, Micro MAX evo