Light Measurement - Lutron Electronics EMC-9400SD Operation Manual

Change the temperature unit ( ℃, ℉ )
If intend to change the Temp. display unit, select to the Type K/J
Thermometer function only,then press the "Unit Button "
( 3-5, Fig.1) continuously,the unit will change from " ℃ "
to " ℉ " sequence, until the desired unit is present on the Display
release the " Unit Button ", the select unit will save into the
memory with default.
4-5 Light Meter measurement
1) Function select to " Light meter " measurement.
2) Plug the " Probe Plug " ( 3-24, Fig. 1 ) into the " Probe
Input Socket " ( 3-17, Fig. 1 ).
Power on the meter by pressing the " Power Button "
( 3-2, Fig. 1 ) once,
3) Hold the Probe by hand and let the " Light sensor "
( 3-22, Fig. 1 ) face against the measurement light source,
the Display ( 3-1, Fig. 1 ) will show the light
measurement value.
Unit change for light measurement
If intend to change the Light unit ( LUX, Ft-cd ),At the light
mode only, press the Unit Button " ( 3-5, Fig.1 ) continuously,
the unit will change from LUX, Ft-cd in sequence, until
the desired unit is present on the Display release the Unit
Button , the select unit will save into the memory with default.
12