Light Measurement; Type K/J Temperature Measurement - Lutron Electronics EM-9300SD Operation Manual

Change the temperature unit (
The meter Temp. display unit is defaulted to "
If intend to let the meter's temperature unit default
to " " , then please refer chapter 7-6 ( page 22 ).
℉
4-5 Light Meter measurement
1) Function select to " Light meter " measurement.
2) Plug the " Probe Plug " ( 3-21, Fig. 1 ) into the " Probe
Input Socket " ( 3-7, Fig. 1 ).
Power on the meter by pressing the " Power Button "
( 3-2, Fig. 1 ) once,
3) Hold the Probe by hand and let the " Light sensor "
( 3-20, Fig. 1 ) face against the measurement light source,
the Display ( 3-1, Fig. 1 ) will show the light
measurement value.
Unit change for light measurement
If intend to change the Light unit ( LUX, Ft-cd ),
press the Unit Button " ( 3-4 ) continuously, the
unit will change from LUX, Ft-cd in sequence, until
the desired unit is present on the Display release the
Unit Button ", the select unit will save into the
memory with default.
℃ ℉
10
, )
".
℃