Humidity/Temp. Measurement; Type K/J Temperature Measurement - Lutron Electronics EMC-9400SD Operation Manual

4-3 Humidity and Temperature measurement
1) Function select to " Humidity/Temp. " measurement.
Plug the " Probe Plug " ( 3-30, Fig. 1 ) into the " Probe
Input Socket " ( 3-18, Fig. 1 ).
2) Power on the meter by pressing the " Power Button "
( 3-2, Fig. 1 ), the LCD shows the unit " %RH " & "
℃ or ℉" at the same time and measured value will
show on the display ( upper display is Humidity value,
the lower display is the temperature value ,Upper right
show Dew value, buttom right show Wet value) .
Change the temperature unit ( ℃, ℉ )
If intend to change the Temp. display unit, select to the Humidity
and Temperature measurement function only,then press the
"Unit Button " ( 3-5 Fig.1) continuously,the unit will change from " ℃ "
to " ℉ " sequence, until the desired unit is present on the Display
release the " Unit Button ", the select unit will save into the
memory with default.
4-4 Type K/J thermometer
1) Function select to " Type K/J thermometer "
2) Plug the Thermocouple Temp. Probe ( Type K Temp.
probe or Type J Temp. probe, optional )Plug( 3-31 Fig.1) into "
Type K/J Probe Input Socket " ( 3-20, Fig. 1 )
The Display will show the measuring value that
sensing from the Temp. probe.
3) If the Display show the indicator " K ", it is ready
for Type K thermometer.
If the Display show the indicator " J ", it is ready
for Type J thermometer.
Change the K type or the J type
The meter is defaulted to " Type K thermometer ".
If intend to select the " Type J thermometer with
default , please refer chapter 7-6 ( page 23 ).
11