Icom IC-M510 Instruction Manual page 104

91
TRIAL MODE - Click here for more information
11
WLAN SETTING
D Client mode
CT-M500 and a mobile device can connect to IC-M510 by the user supplied access point.
Set the CT-M500 in the "CT-M500 settings" of the IC-M510.
IC-M510
1. Open the "Configuration" screen.
See steps 1 ~ 4 on page 88.
2. Select "Client."
Change setting?" is displayed, Push
• The transceiver starts searching the access point.
3. A list of the network device is displayed.
4.
access point and then push [ENT], or [CH/ENT].
5. Select the Static IP address or the Global IP address
according to your network environment.
When you select the "Manual," enter the IP Address
and the Subnet Mask.
6. If necessary, enter the SSID or the password, or
select the Security type.
Enter the SSID up to 32 characters.
Enter an authentication password of 8 to 63
characters.
• The transceiver starts connecting to the access point.
Access point
(User supplied)
OK .
CT-M500
RS-M500