Control Panel Features; Connect Button; Fan Button; Sleep Button - Midea MAP User Manual

Control Panel Features

Swing (Connect)
Button
Timer
Button
Swing Button
Used to initiate the Auto Swing feature. When the
operation is ON, pressing the SWING button can
stop the louver at the desired angle.

Connect Button

Also used to initiate the wireless connection mode.
To initiate the wireless connection mode, power on
the air conditioner then press the SWING button
for 3 seconds. The LED DISPLAY will show 'AP' to
indicate the unit is in wireless connection mode.
Refer to the app connection instructions to
the connection process.
If the connection is successful, the unit will exit
wireless connection mode and illuminate the
wireless LED. If the connection fails, the unit will
exit wireless connection mode automatically after 8
minutes and the wireless LED does not illuminate.
Note: The wireless connection process must be
completed within 8 minutes after powering the air
conditioner on.
Timer button
Used to initiate the AUTO ON start time and AUTO
OFF stop time program. The timer on or o
illuminate depending on the selected setting.

Fan button

Controls the fan speed. Press to control the fan speed in
four steps - LOW, MID, HIGH and AUTO. The selected fan
speed light will illuminate.
NOTE: Applicable to models with the Constant Fan
feature. In COOL or DRY mode, press the Fan button for
When the function is turned on, the constant fan
light will illuminate, indicating the fan will run
constantly, independent of compressor operation.
User Manual
Wireless Indicator
Mode Up ( ) and Down ( )
Button
the constant fan function.
LED Display
Buttons
Button
light will go out, indicating that the fan will stop
when the compressor stops.
Mode button
Selects the desired operating mode. Each time
you press the button, a mode is selected in a
sequence that goes from AUTO, COOL, DRY,
FAN and HEAT (cooling only models excluded).
The mode light illuminates and indicates the
selected mode.
sh
Up ( ) and Down (
Used to increase/decrease temperature
settings in 1° increments in a range of
60°F/16°C to 86°F/30°C or the TIMER setting in
a range of 0 ~ 24hrs.
To change between °F or °C, simultaneously
press and hold the Up and Down buttons for
3 seconds.
Power button
Power switch on/o

Sleep button

t will
Press SLEEP button to initiate the SLEEP operation
and the sleep light illumiantes.Press SLEEP button
again to stop the SLEEP operation and the sleep
light turns dark. Press SLEEP button for 3 seconds
operation. The LED(the light above the button)
will illuminate after 250 hours of operation.
LED display
Shows the set temperature in °F (Degrees
Fahrenheit) or °C (Degrees Celsius) and the
Auto-timer settings. While on FAN modes,
it shows the room temperature.
Power Button
Fan Sleep
Button
, the constant fan
) buttons
Page 9