Cool/Heat Operation; Dry Operation; Fan Operation; Timer: Auto Start/Stop Operation - Midea MAP User Manual

Sh ows Error codes and protection code:
The unit may stop operation or continue to run safely.
If the error codes appear, wait for about 10 minutes.
The problem may resolve itself. If not, disconnect the
power, then connect it again. Turn the unit on. If the
problem persists, disconnect the power and contact
your nearest customer service center.
Error code appears andbegins with the
letters as the following in the window
display of indoor unit:EH(xx), EL(xx), EC(xx), PH(xx),
PL(xx), PC(xx)
Operating Instructions
COOL operation
• Press the "MODE" button until the "COOL" indicator
light comes on.
• Press the ADJUST buttons Up ( ) or Down ( ) to
select your desired room temperature. The temperature
can be set within a range of 60°F~86°F/16°C~30°C.
• Press the "FAN SPEED" button to choose the fan speed.
HEAT operation
• Press the "MODE" button until the "
light comes on.
• Press the ADJUST buttons Up ( ) or Down ( ) to
select your desired room temperature. The temperature
can be set within a range of 60°F~86°F/16°C~30°C.
• Press the "FAN SPEED" button to choose the fan
speed. For some models, the fan speed cannot be
adjusted while in HEAT mode.

DRY operation

• Press the "MODE" button until the "DRY" indicator
light comes on.
• While in this mode, you cannot select a fan speed
The fan motor operates at AUTO speed.
• Keep windo ws and doors closed for the best
ect.
• Do not put the duct to window
AUTO operation
• When you set the air conditioner to AUTO mode, it
will automatically select cooling, heating (cooling
only models excluded), or fan only operation
depending on what temperature you have selected
and the current room temperature.
• The air conditioner will control room temperature
automatically according to the temperature point
set by you.
Page 10
P1 - Bottom tray is full - Connect the drain hose
NOTICE
the unit and check for any obstructions. Restart
the Unit. If the malfunction persists, turn
contact customer service at 1-855-204-5313.
• Under AUTO mode, you cannot select the fan

FAN operation

• Press the "MODE" button until the "FAN"
• Press the "FAN SPEED" button to choose the fan
• Do not connect the duct to a window.
HEAT " indicat or

TIMER: Auto Start/Stop Operation

• When the unit is on, pressing the Timer button
• Press or hold the Up ( ) or Down ( )
• The system will automatically revert back to
• Turning the unit ON or OFF at any time or
• Should a malfunction occur, the Auto Start/Stop
and drain the collected water away. If
protection code repeats, call for service.
the unit and unplug the power cord and
speed.
indicator light comes on.
speed. The temperature cannot be adjusted.
will initiate the Auto stop program. The TIMER
OFF indicator light illuminates. Press the Up
( ) or Down ( ) button to select the desired
time. Press the TIMER button again within 5
seconds. The Auto start program is initiated
and the TIMER ON indicator light illuminates.
Press the Up ( ) or Down ( ) button to select
the desired Auto start time.
, press the Timer button to
initiate the Auto start program. Pressing it again
ve seconds will initiate the Auto stop
program.
button to change the Auto time by 0.5 hour
increments, up to 10 hours, then at 1 hour
increments up to 24 hours. The control will
count down the time remaining until start.
display the previous temperature setting if
there is no operation within 5 seconds.
adjusting the timer setting to 0.0 will cancel the
Auto Start/Stop timer program.
timed program will also be cancelled.
User Manual