Operating Instructions; Control Panel Features - Midea MAP12S1TBL Owner's Manual & Installation Manual

Operating Instructions

Control Panel Features

NOTE: The following control panels
purchased may be slightly different according to the models. Your machine may not contain some indicators or
buttons. The actual shape shall prevail.
Wireless
Wireless button(On some models)
Used to initiate the wireless connection mode. For
Wireless
the first time to use wireless function, press the
wireless button for 3 seconds to initiate the wireless
connection mode. The LED DISPLAY shows 'AP' to
indicate you can set wireless connection. If
connection(router) is successful within 8 minutes,
the unit will exit wireless connection mode
automatically and the wireless indicator illuminates.
If connection is failure within 8 minutes, the unit
exits wireless connection mode automatically. After
Wireless connection is successful, for some models
you can press Wireless and DOWN (-) buttons at
the same time for 0.5 seconds to turn off Wireless
function and the LED DISPLAY shows 'OF' for 3
seconds, press Wireless button to turn on Wireless
function and the LED DISPLAY shows 'ON' for 3
seconds.
NOTE: When you restart the wireless function, it may
take a period of time to connect to the network
automatically.
Swing button(On some models)
(Applicable to the models with auto swing feature
only)
Used to initiate the Auto swing feature. When the
operation is ON, press the SWING button can stop the
louver at the desired angle.
Sleep(Eco)/Filter button
Used to initiate the SLEEP/ECO operation.
NOTE: After 250 hours of operation, the filter indicator
 
Page 18
are for explanation purpose only. The control panel of the unit you
Constant
fan
Constant fan
(Press 3s)
light illuminates. This feature is a reminder to
clean the Air Filter for more efficient operation.
Press this button for 3 seconds to cancel the
reminder.
Timer button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjuction
with the + & - buttons. The timer on/off
indicator light illuminates under the timer
on/off settings.
Fan/Constant fan(On some models) button
Control the fan speed. Press to select the fan
Constant fan
(Press 3s)
speed in four steps-LOW, MID(MED), HIGH
and AUTO. The fan speed indicator light
illuminates under different fan settings.
NOTE: In cooling or Dry mode, press the button
for 3 seconds to turn on or off the constant fan
function. When the function is turned on, the
constant fan light will illuminate, identifying
the fan continuous run for cooling. When the
function is turned off, the constant fan light
will go out, identifying the fan cycle run with
compressor stop.
On some models Ion light is instead of
constant fan light.
Press the button for 3 seconds, the Ionizer is
energized and will help to remove pollen
and impurities from the air.