Sliding Window Installation - Midea MAP User Manual

Foam seal C
(Non-adhesive type)
Security Bracket
2 Screws
Foam seal A
(Adhesive
type)
Window slider B
(if required)
Window slider A
User Manual
3. Cut the non-adhesive foam seal C strip to match the width
of the window. Insert the seal between the glass and the
window frame to prevent air and insects from getting into
the room.
4. If desired, install the security bracket with 2 screws as
shown.
5. Attach the Hung Window Adapter to the hose by lining up
the circles on the adapter the hose. Insert the window slider
adapter into the hole of the window slider.
Type 2: Sliding window Installation (Optional)
Foam seal B
(Adhesive
1. Cut the adhesive foam seal A and B strips to the proper
type-shorter)
lengths, and attach them to the window sash and frame
as shown.
2. Insert the window slider assembly into the window opening.
Insert the slider assembly into the window opening. If the
hose opening is covered by the window frame, rotate the
panel so the thicker side faces the window frame.
Attach the Window Kit Brace to the back of the hose panel –
trim the brace if necessary.
Window
Kit Brace
Page 17