Air Hose Insulator Installation (Only For Heat Pump Mode) - Midea MAP User Manual

Foam seal C
(Non-adhesive type)
Security
Bracket
2 Screws
Air hose insulator Installation(only for heat pump mode)
NOTE: When the unit is at heat mode, the Air Hose insulator must be fixed in the hose of unit.
Air hose insulator
1. Cover the Air Hose with the
Air Hose insulator.
Page 18
3. Cut the non-adhesive foam seal C strip to match the
window height. Insert the foam seal between the glass and
the window frame to prevent air and insects from getting
into the room.
4. If desired, install the security bracket with 2 screws as shown.
5. Attach the Sliding Window Adapter to the hose by lining up
the circles on the adapter the hose. Insert the window slider
adapter into the hole of the window slider.
hose
2. Pull out the Air Hose and cut
the useless part of the Air Hose
insulator.
3. Tighten the air hose with the
Ribbons and cut useless part.
User Manual
Ribbon