Table of Contents
Advertisement
Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 20-101-1194 - MODULE RABBITCORE RCM3309 ROHS
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
4.1 RCM3309/RCM3319 Digital Inputs and Outputs
Figure 5 shows the RCM3309/RCM3319 pinouts for headers J3 and J4.
GND
PA7
PA5
PA3
PA1
PF3
PF1
PC0
PC2
n.c./PC4
PC6-TxA
PG0
PG2
PD4
PD2/TPO–
PD6/TPI–
LINK/n.c.
The pinouts for the RCM3000, RCM3100, RCM3200,
RCM3319, RCM3360/RCM3370,
ble, except signals PB0, PC4, and PC5. PB0, PC4, and PC5 are used for the SPI interface to the
RCM3305/
serial flash on the
information.
standard 2 × 34 headers with a nominal 2 mm pitch. An RJ-45
Headers J61 and J62 are
Ethernet port is also included with the RCM3309/RCM3319.
Pins 29–32 on header J61 are configured using 0 Ω resistors at locations JP9, JP10, JP7,
and JP8 to be PD2, PD3, PD6, and PD7 respectively. They may also be reconfigured to
carry the Ethernet signals TPI+, TPI–, TPO+, and TPO–, but this capability is reserved for
future use.
Pins 33 and 34 on header J62 are wired to carry the
the corresponding LEDs on the RCM3309/RCM3319 module. These pins may be "config-
ured" to carry PD0 and PD1, an option that is reserved for future use.
See Appendix A.5 for more information about the locations of these headers.
22
J61
STATUS
PA6
PA4
PA2
PA0
PF2
PF0
PC1
PC3
n.c./PC5
PC7-RxA
PG1
PG3
/IORD
PD5
SMODE1
PD3/TPO+
VRAM
PD7/TPI+
+3.3 VIN
ACT/n.c.
n.c. = not connected
These pinouts are as seen on
the
of the module.
Figure 5. RCM3309/RCM3319 Pinouts
RCM3365/RCM3375, and RCM3900
RCM3309/RCM3315/RCM3319. Visit the
J62
/RES
n.c./PB0
PB2
PB3
PB4
PB5
PB6
PB7
PF4
PF5
PF6
PF7
PE7
PE6
PE5
PE4
PE3
PE1
PE0
PG7
PG6
PG5
PG4
/IOWR
SMODE0
/RESET_IN
VBAT_EXT
GND
n.c.
GND
RCM3300/RCM3305/
are almost compati-
Web site
and
signals that illuminate
LINK
ACT
RabbitCore RCM3309/RCM3319
RCM3309/
for further
Advertisement
Table of Contents
