Prototyping Board Features - Rabbit RabbitCore RCM3309 User Manual

Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 20-101-1194 - MODULE RABBITCORE RCM3309 ROHS
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
B.1.1 Prototyping Board Features
Power Connection
•
nection to the power supply. Note that the 3-pin header is symmetrical, with both outer
pins connected to ground and the center pin connected to the raw V+ input. The cable
of the AC adapter provided with Development Kit ends in a 3-pin plug that connects to
the 3-pin header (J2)—the center pin of J2 is always connected to the positive terminal,
and either edge pin is negative.
Users providing their own power supply should ensure that it delivers 8–30 V DC at 1 A.
Regulated Power Supply
•
routed to a 5 V switching voltage regulator, then to a separate 3.3 V linear regulator.
The regulators provide stable power to the RCM3309/RCM3319 module and the Proto-
typing Board. The voltage regulators will get warm while in use.
Power LED —The power LED lights whenever power is connected to the Prototyping
•
Board.
Core LED —The core LED lights whenever an RCM3309/RCM3319 module is
•
plugged in correctly on the Prototyping Board and the RCM3309/RCM3319 module is
not being reset.
—The relay LED lights whenever the Prototyping Board relay is energized.
• Relay LED
—A momentary-contact, normally open switch is connected directly to the
• Reset Switch
RCM3309/RCM3319's
the system.
• I/O Switches and LEDs
nected to the PG0 and PG1 pins of the RCM3309/RCM3319 module and may be read
as inputs by sample applications.
Four user LEDs (DS3–DS6) are connected to alternate I/O bus pins PA0–PA3 pins of
the RCM3309/RCM3319 module via U8, and may be driven as output indicators. PE7
and PG5 control the registers in U8 as shown in the sample applications.
—A generous prototyping area has been provided for the installation
• Prototyping Area
of through-hole components. +3.3 V, +5 V, and Ground buses run along one edge of
this area. Several areas for surface-mount devices are also available. Each SMT pad is
connected to a hole designed to accept a 30 AWG solid wire.
• LCD/Keypad Module
headers LCD1JA, LCD1JB, and LCD1JC. The signals on headers LCD1JB and
LCD1JC will be available only if the LCD/keypad module is plugged in to header
LCD1JA. Appendix C provides complete information for mounting and using the
LCD/keypad module.
User's Manual
—A power-supply jack and a 3-pin header are provided for con-
—The raw DC voltage provided at the POWER IN jack is
/RESET_IN pin. Pressing the switch forces a hardware reset of
—Two momentary-contact, normally open switches are con-
—Rabbit's LCD/keypad module may be plugged in directly to
83