Start-Up; General Instructions For Programming - KROHNE OPTISONIC 6300 Handbook

START-UP

5

5.1 General instructions for programming

Human machine interface (HMI) Human machine interface (HMI)
Human machine interface (HMI) Human machine interface (HMI)
Figure 5-1: Display and operating elements (Example: flow indication with 2 measuring values)
1 Indicates a possible status message in the status list
2 Tag number (is only indicated if this number was entered previously by the operator)
3 Indicates when a key has been pressed
4 1st measured variable in large depiction
5 Bargraph indication
6 Keys (see table below for function and depiction in text)
7 Interface to the GDC bus (not present in all signal converter versions)
8 Infrared sensor (not present in all signal converter versions)
Key Measuring mode
> Switch from measuring
mode to menu mode;
press key for 2.5 s,
"quick start" menu is
then displayed
-
^
↓ or ↑
Switch between display
pages: measured
value 1 + 2, trend page
and status page(s)
Esc (> + ↑)
-
Table 5-1: Description of key functionality
56
Menu mode
Access to displayed
menu, then 1st
submenu is displayed
Return to measuring
mode but first ask
whether the data should
be saved
Select menu
-
www.krohne.com
Sub-menu or function
mode
Access to displayed sub-
menu or function
Press 1 to 3 times,
return to menu mode,
data saved
Select sub-menu or
function
Return to menu mode
without acceptance of
data
07/2009 - 4000263902 - HB OPTISONIC 6300 R03 en
OPTISONIC 6300
Parameter and data
mode
For numerical values,
move cursor
(highlighted in blue) one
position to the right
Return to sub-menu or
function, data saved
Use cursor highlighted
in blue to change
number, unit, setting
and to move the decimal
point
Return to sub-menu or
function without
acceptance of data