Table of Contents
Advertisement
10 Appendix
10.1 FCC Statements
10.2 Equipment usage
10.3 Compliance Statement (Part 15.19)
10.4 Warning (Part 15.21)
10.5 Compliance Statement (Part 15.105(b))
41
WSN Monitor shows
NO DATA in the Sensor
Data Graph Pane.
Node titles displayed on
the Topology Pane do
not show node
destinations.
At WSN Monitor startup,
all node's LEDs are
blinking, or none of
them is flashing.
Neither Serial
Bootloader nor other
application work with a
node, except for the
Hardware Test.
This equipment is for use by developers for evaluation purposes only and must not be
incorporated into any other device or system.
These devices comply with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
1. These devices may not cause harmful interference, and
2. These devices must accept any interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly approved by Atmel Norway could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
No node is selected. Select the required node by mouse-
clicking on it.
The displayed titles do not necessarily relate to the node
functions but they can be redefined by user anytime.
These names are stored in the node title file (see Section
4.5) along with MAC addresses mapped to the nodes.
The WSNDemo application was not uploaded into the
node. Upload this application to the node.
Make sure that J3 is set on the board properly to
correspond to the actual connection type (either Serial or
USB).
Make sure the microcontroller flash memory was not
erased before, and the bootstrap was not lost there after
having the node programmed through JTAG.
ATZB-EVB-XXX-XXX User Manual
AVR-09-2011
Advertisement
Table of Contents
