Vega VEGADIS 61 Operating Instructions Manual page 15

VEGADIS 61
Fig. 6:
Connection steps 6 and 7
8 Push down the opening lugs of the terminals, the
terminal spring closes clearly audibly
9 Check the hold of the wires in the terminals by
slightly pulling on them
10 Connect screen to ground terminals
11 Connect the ground terminals on the housing ex-
terior to a low-impedance ground
12 Tighten the compression nut of the cable entry
firmly, the seal ring must completely encircle the
cable
13 Press PLICSCOM lightly onto the electronics and
turn it to the right until it snaps in
14 Screw on the housing cover.
The electrical connection is finished.
Connecting to the sensor
15