Installing Expansion Functional Module - JHCTech KMDA-3921 User Manual

User's Manual
details, please refer to the above chapter "2.5.2 Installing Mini PCIe Module -Step 1"
Step 2: Hold the M.2 module with its notch aligned with the NGFF socket of the mother board and insert
it at a 30 degrees angle into the socket (Note: Pay attention to avoiding the hard disk cable during the
installation process);
Step 3: Screw one screw to the holder as shown in the picture.
Step 4: Follow the reverse steps of disassembly to complete the product installation.

2.4.5 Installing Expansion Functional Module

(Note: this operation is only for KMDA-3921/3920, and KMDA-3610 does not support the
installation of PCIe/PCI expansion module. Here is an example of KMDA-3921, and the installation
of KMDA-3920 is similar)
Step 1: The step here is the same as above chapter "2.5.2 Installing Mini PCIe Module -Step 1", For
details, please refer to the above chapter "2.5.2 Installing Mini PCIe Module -Step 1"
Step 2: Unscrew 4 screws on 4 bars, take off 4 bars;
40