Print Bar Code - Dymo LabelWriter SE300 User Manual

GS k
DESCRIPTION
Prints a bar code at the current position in the current orientation.
The n parameter selects the symbology to be printed. (See the
table below.) The m parameter specifies how many characters are
to be encoded as part of the bar code. If the number of characters
to be encoded is variable, the m parameters can be set to zero.
This will cause the printer to read the next character sent as a
delimiter character. Further characters will then be encoded into
the bar code until a character is found that matches the start
character.
EXPRESSION
ASCII GS
Decimal 29
Hex 1D
PARAMETERS
n = Selects the bar code symbology to be used
m = Specifies the number of characters to be encoded. Also
specifies which EAN/UPC symbology will be used.
d1..dm = The data characters to be encoded.
For an example of this command using the Caret feature see page
101, Example 37.
k n m
107 n m
6B n m

Print Bar Code

d1...dm
d1...dm
d1...dm
4-71