Set Dot Tab - Dymo LabelWriter SE300 User Manual

ESC B
DESCRIPTION
Provided for LabelWriter EL compatibility. ESC B defines the
left-hand starting position for the placement of EL mode bitmap
data. ESC B is used in conjunction with the SYN (EL Mode
Graphics) and ETB (EL Mode Compressed Graphics) commands.
The LabelWriter SE300 prints up to 56 bytes (448 dots) of bitmap
data. ESC B allows the starting point (the left margin) to be
relocated from the default position (byte 0), which is the extreme
left side of the label, to any point, up to the right-hand margin
(byte 56). The increments for relocating the starting point are in
millimeters. Use of this command, along with the ESC D
command, can drastically reduce the number of data bytes
required to skip blank areas.
SEE ALSO
ESC D
SYN
ETB
EXPRESSION
ASCII
Decimal
Hex
PARAMETERS
n1 = starting position from the left in millimeters (default = 0)
n1 = 0 to 55
EXAMPLE
For an example of this command's usage, see Appendix A, page
85, Example 12.
For an example of this command using the Caret feature see page
96, Example 12
4-40
ESC B n1
27 66 n1
1B 42 n1

Set Dot Tab