Interior Maintenance - Dymo LabelWriter SE300 User Manual

2. Dirt, dust, ink and so on will more than likely be attracted
to the exterior of your printer. Use the lint-free cloth to
wipe the exterior of the printer. Remove dirt and ink
smudges with either isopropyl alcohol, diluted
dishwashing detergent, or diluted glass cleaner. Avoid
products containing ammonia when you clean the printer
or plastic cover.
3. Take a minute to clean the work area around the
LabelWriter SE300. There are probably a few labels
(new and used) laying around!
4. Reconnect the power cord and turn on the printer.

Interior Maintenance

The printer's top cover will keep out most of the dust and dirt
which accumulates in operating areas. However, it is still a good
idea to periodically perform some basic interior maintenance.
1. Turn the printer off and disconnect the power cord.
2. Open the top cover.
3. Use a soft brush to clean inside the printer. A small, soft
paint brush will whisk away paper dust and other stray
particles from the inside of the printer. Remove the roll of
labels to clean under the roll, and then replace the labels.
4. Close the top cover.
5. Reconnect the power cord and turn the printer on.
B-106