QDI PlatiniX P8/333 Series Manual page 52

Appendix Appendix Appendix Appendix Appendix
3. Hot key for Recovery
There are 12 options, including NULL and F2~F12. Key F12 is default. If NULL is selected,
Restore interface can not be used with pressing hotkey. If you select one key of the rest
11 options, you can enter Recover interface by pressing the hotkey you setup during
POST.
Hard Disk Selection Menu
If you installed the system with several IDE
hard disks, and you have pressed the
backup or restore hotkey during POST, hard
disk selection menu will popup before you
enter backup or recovery interface, in which
all of the IDE hard disks installed on your
system will be listed. You can scroll the high-
light bar to the hard disk you want to work
with using arrow key. Press ENTER to
50
confirm, and the following operation will be
performed on the selected hard disk:
Backup Function Introduction
press Backup Hotkey to enter Backup Interface during the POST(Power On Self Test),
then the follwing interface will appear. You can scroll the highlight bar to the option you
want to work with using arrow key. Press ENTER to confirm.
Note:
If the Backup hotkey and Recover hotkey have been set with
the same key, the default will be Backup hotkey.
figure-3 Backup Interface
figure-2 Hard Disk Select
1 Backup Partition Table
2 Backup System Partition C:
3 Backup Whole Disk
4 Backup CMOS Setup
5 Free Backup Area
6 Exit Backup Menu
QDI QDI QDI QDI QDI