Jumper Settings; Wake-Up Function(Jusb, Jfusb) - QDI PlatiniX P8/333 Series Manual

Chapter 2 Chapter 2
Chapter 2 Chapter 2 Chapter 2

Jumper Settings

Jumpers are located on the mainboard, the clear CMOS jumper CLR_CMOS, enable key-
board password power-on function jumper JKB etc. Pin 1 for all jumpers are located on the
side with a thick white line (Pin1→
Jumpers with three pins will be shown as
and to represent pin2 & pin3 ("2-3") closed.
Jumper
Enable Front/Back Panel USB Device Wake-up Function (JFUSB/JUSB)
(optional)
The mainboard provides the advanced USB device wake-up function. The system can be
waked up from its power saving status including ACPI S3 by activating USB device. Before
using this function, set JFUSB/JUSB with pin1 & pin2 closed. Otherwise, set JFUSB/JUSB
with pin2 & pin3 closed for disabling. Furthermore, the item "Wake-Up From S3 by USB"in
Power Management Setup should also be set correspondingly to enable or disable this
function.
), referring to the mainboard's silkscreen.
Symbol Description
1-2 1-2 1-2
1-2 1-2
2-3 2-3 2-3 2-3 2-3
close
open
JUSB
JFUSB
to represent pin1 & pin2 ("1-2") closed
Represent
set pin1 and pin2 closed
set pin2 and pin3 closed
set the pins closed
set the pins opened
1 2 3
1 2 3
Enable
Disable
1
1
2
2
3
3
Disable Enable
17
PlatiniX 8/333 PlatiniX 8/333 PlatiniX 8/333 PlatiniX 8/333 PlatiniX 8/333